304 Stainless Steel 10inch Housing Pre Filtration System with 40 Micron SS Filter Cartridge for Industrial Use
Basic Properties
Trading Properties
Product Summary
Product Details
40 micron Pre Filtration System
,304 Stainless Steel Water Prefilter
,10inch housing SS Filter Cartridge
Product Description
- Bottom Spring Plate: Compression spring continuously pushes cartridge upward, preventing shifting and gap formation during pressure fluctuations
- Top Lid Groove: Molded groove centers and locks cartridge in place when lid closes
- Sandwiched Cartridge Design: Spring pushes up, lid groove presses down - cartridge held rigid between two fixed points
- Single Retaining Ring: Snap ring (circlip) secures lid - no bolts, clamp handles, or threaded rods required
- Compact Closure: Flush external profile with no protruding hardware
- Quick Reassembly: Under 2 minutes with intuitive installation process
- Side-Slip Prevention: Lid groove captures cartridge ID, preventing lateral movement and bypass channels
- Smallest Footprint: Ideal for tight skid layouts and crowded equipment rooms
- Lower Parts Cost: Standard stamped components reduce overall housing cost
- 5": Point-of-use, small skids, lab applications, low flow (1-3 m³/h)
- 10": Point-of-use, small skids, lab applications, low flow (3-5 m³/h)
- 20": General industrial use, medium flow (6-10 m³/h), 2x the dirt capacity of 10"
- Close inlet valve / shut off pump
- Relieve pressure (bleed valve or slightly loosen clamp)
- Loosen clamp ring
- Lift lid
- Remove old cartridge
- Insert new cartridge (check gasket seated)
- Close lid, secure clamp
- Repressurize, check for leaks
- Pressure drop: Install gauges before and after housing. Change cartridge when differential reaches 2-3 bar
- Flow drop: Same pump setting but noticeably less output indicates loaded cartridge
RELATED PRODUCTS
10inch 133mm Stainless Steel Filter Housing with High-Pressure Resistance and Clamp Closure Design for Water Treatment
Industrial stainless steel filter housing with clamp closure for quick cartridge swaps without pipe disconnection. SS304/316L construction, 0.1-1.0Mpa pressure rating, 5-10 year service life. Accepts standard cartridges (1-100μm) for water treatment, chemical, food & pharmaceutical applications. OEM available.
20"X4.5" Industrial High Working Pressure 2mm Thickness Stainless Steel Housing Clamp Opening Liquid Treatment Water Prefilter
PRODUCT HIGHLIGHTS Clamp Closure Design: Features a quick-opening clamp ring (often a wing-nut or T-bolt clamp) instead of traditional flange bolts. No Pipe Disconnection: The top-load design allows you to open the clamp and lift out the cartridge without unbolting the housing or disconnecting inlet...
20inch 304 Stainless Steel Home Pre-filter with Clamp Closure Design and High-Pressure Resistance for Sediment Filtration
20-inch stainless steel whole house water filter housing with clamp closure design for quick cartridge replacement without pipe disconnection. Features 304 stainless steel construction, 40-micron filtration, 5000-8000L/H flow rate, and 5-10 year service life. Suitable for home, office, and industrial applications.
30inch 133 Jumbo Housing Top Load Cartridge Home Pre-filter with Clamp Closure for Fast Replacement Without Pipe Disconnection
SS304 jumbo housing handles 15000-20000L/H at 5-100 microns with 5-10 year service life. Clamp closure enables fast cartridge swaps without pipe disconnection, cutting downtime and labor costs. OEM options available.
